summaryrefslogtreecommitdiffstats
Commit message (Collapse)AuthorAgeFilesLines
* [pim] ssmpingd commandspim0.158Everton Marques2009-10-081-0/+3
|
* [pim] Sample config for ssmpingd supportEverton Marques2009-10-081-0/+6
|
* [pim] T41 DONE ssmping supportEverton Marques2009-10-087-13/+195
|
* [pim] Hooks for ssmpingd supportEverton Marques2009-10-087-11/+418
|
* [pim] Skeleton for ssmpingd supportEverton Marques2009-10-0710-2/+164
|
* [pim] Ref. on LW-MLDv2Everton Marques2009-10-021-0/+1
|
* [pim] Hint for test_igmpv3_join command-line utilityEverton Marques2009-10-021-0/+12
|
* [pim] Command line tool to test IGMPv3 join.Everton Marques2009-10-026-30/+254
|
* [pim] clean-upEverton Marques2009-10-022-3/+0
|
* [pim] ip mroute show: can display the MFCEverton Marques2009-10-021-0/+4
|
* [pim] Version up to 0.158Everton Marques2009-10-021-1/+1
|
* [pim] Fixed doc on CAVEAT C7Everton Marques2009-10-021-1/+1
|
* [pim] show ip pim lan-prune-delay: fix cosmetic alignmentEverton Marques2009-10-021-1/+1
|
* [pim] More RPF cache refresh statisticsEverton Marques2009-10-024-10/+18
|
* [pim] Correction for cross-compilation error with this syntaxLeonard Herve2009-10-022-11/+24
|
* Router Alert option for IGMP packets but not for PIM packetsLeonard Herve2009-10-021-2/+2
|
* [pim] RPF cache refresh statisticsEverton Marques2009-10-024-10/+34
|
* [pim] Move encoded source address length check to pim_parse_addr_sourceEverton Marques2009-10-023-26/+20
|
* [pim] igmpv3: specific query interval set to 1 second (RFC 3376 8.8.)Leonard Herve2009-10-028-29/+80
| | | | | | | [pim] pim messages: encoded source address format with Sparse bit=1 (RFC 4601 4.9.1.) [pim] and Mask Len MUST be equal to 32 [pim] dr election: new traces [pim] fix triggered_hello_delay_msec randomization
* [pim] Log physical interface up/downEverton Marques2009-10-0214-62/+85
| | | | | | | | | [pim] Replace strerror with safe_strerror [pim] Fix PIM socket removal from non-PIM interfaces [pim] show ip igmp querier: left-align Querier string [pim] Version up to 0.157 [pim] Recipe to re-sync with Quagga repository [pim] Build vtysh in development script
* [pim] pim commands added to vtyshLeonard Herve2009-10-027-154/+207
|
* [pim] Initial pim 0.155Everton Marques2009-10-0292-18/+21813
|
* [ospfd] enable more OSPF cost command aliasesDenis Ovsienko2009-09-281-0/+88
| | | | | | | | | | | | The following syntax forms were not historically supported by Quagga, although IOS accepted them w/o a problem: no ip ospf cost <1-65535> no ospf cost <1-65535> no ip ospf cost <1-65535> A.B.C.D no ospf cost <1-65535> A.B.C.D From now on Quagga also supports these variants.
* zebra: Fix router advertisements for non-Ethernet link layer addressesDavid Ward2009-09-011-2/+16
| | | | | * rtadv.c: round up when calculating the link-layer address option length; add padding to the option if needed to end on an octet boundary
* release: 0.99.15quagga_0_99_15_releasePaul Jakma2009-08-281-1/+1
| | | | * configure.ac: Bump to 0.99.15
* ospf6d: bug #529, fix endianness problem in earlier commit Tom Henderson2009-08-281-7/+4
| | | | | | * ospf6_lsa.c: (ospf6_lsa_age_current) arithmetical compares make no sense in non-host order..
* bgpd: fix md5 set on listen socketsStephen Hemminger2009-08-281-9/+10
| | | | | | * bgp_network.c: (bgp_md5_set) Missing piece from earlier listener change did not get ported from Vyatta code into upstream. The list listener_sockets changed from (int *) to (struct bgp_listener *).
* lib/trivial: str2prefix checks return of inet_pton in fragile wayPaul Jakma2009-08-281-2/+2
| | | | | * prefix.c: (str2prefix_ipv6) inet_pton succesful return is presumed to be 1, rather than the "not zero" the man page describes - seemed fragile.
* zebra: Add an example config file for testzebraPaul Jakma2009-08-281-0/+56
| | | | * testrib.conf: Example config file for testzebra
* zebra: test_main.c should be a bit more helpful about its usagePaul Jakma2009-08-281-1/+5
| | | | * test_main.c: If required arguments are missing, say that.
* lib: if_lookup_by_name should be more robust to null argumentPaul Jakma2009-08-281-7/+9
| | | | * if.c: (if_lookup_by_name) shouldn't crash just cause we got a NULL name
* ospfd: Make sure priority is respected.Joakim Tjernlund2009-08-281-1/+1
| | | | | * ospf_ism.c (ospf_dr_eligible_routers) should test for priority > 0 instead of != 0 as ospf_nbr_new () initially sets prio to -1
* ospfd: Tighten up the connected check for redistributionJoakim Tjernlund2009-08-281-8/+5
| | | | | | * ospf_zebra.c: (ospf_distribute_check_connected) check to make filter out routes matching connected routes was matching against OSPF networks, which can be far more general than the actual connected interfaces. Fix.
* all: check return value from daemon() callStephen Hemminger2009-08-139-17/+45
| | | | | | * */*main.c: (main) Current versions of Gcc warn if the return value for daemon() is not checked. So add a simple test and exit on failure.
* bgp: missing pieces from listener patchStephen Hemminger2009-08-131-10/+5
| | | | | | | * bgp_network.c: (bgp_accept) The code in current git will crash as part of the revised listener code is missing. The new listener thread code passes a pointer to a bgp_listener structure, not the bgp pointer. The old code always got a NULL for bgp pointer, so that is now hard coded.
* bgp: compiler warning fixStephen Hemminger2009-08-131-2/+2
| | | | | * bgp_filter.h: Gcc complains the function prototype is not correct because the function argument is using old K&R style.
* ospfd: fix performance problem with redistribute deleteStephen Hemminger2009-08-132-14/+4
| | | | | | | | | | | | Doing redistribute delete with full BGP table was taking 30 minutes, this drops it down to less than a second. * ospf_lsa.c: (ospf_lsa_maxage) When flushing lots of entries the performance is terrible because it looks up each LSA entry through ospf_lsa_maxage_exist before deleting causing O(N^2) performance. Use a new OSPF_LSA_MAXAGE flag instead of scan - and maintain it. (ospf_lsa_maxage_exist) removed (ospf_lsa_maxage_delete) maintain OSPF_LSA_MAXAGE flag
* ospfd: Make sure route table is recalculated.Joakim Tjernlund2009-08-111-18/+23
| | | | | | | | | | | | | | | In some cases ospfd does not recalc the route table. This happens when ospfd receives an old LSA which will trigger recalc but the this recalc will fail because all interfaces isn't up yet. Next LSA that is originated matches the old one so no recalc will be performed. This problem has been observed when there are only 2 ppp I/Fs in an area, both go down at the same time, then they come up again with a few seconds apart. * ospf_lsa.c: (ospf_{router,network}_lsa_install) avoid a needless scheduling of SPF. (ospf_lsa_different) fix bug in LSA comparison that would lead to the described failure to schedule SPF.
* ospfd: Make "Packet ... received on wrong link" conditional on debugPaul Jakma2009-08-111-2/+3
| | | | | | * ospf_packet.c: make this message conditional on 'debug ospf event', as it be easily triggered with, e.g., multiple subnets sharing same physical network. E.g, see bug #532.
* bgpd: Fix mistakes in applying 'allow inbound connections to non-default view'Paul Jakma2009-08-051-26/+28
| | | | | | * bgpd.c: (peer_lookup_with_open) Bodged application of previous patch meant the second loop around bgp->peer wasn't included in the loop around bm->bgp as it was supposed to be. Fix..
* ospfd: neuter some compiler warningsPaul Jakma2009-08-031-38/+1
| | | | | | * ospf_lsa.c: (link_info_set) Use %zd for size_t - C99 is old enough now. Lots of similar warnings all over the code. (ospf_lsa_translated_nssa_compare) Unused func - delete.
* ospfd: update some commentsPaul Jakma2009-08-032-7/+17
| | | | | * ospf_{spf,lsa}.c: remove out of date comment; add comment on some non-obvious code; Make note of a possible scaling problem.
* ospfd: Change struct ospf_path *oi to ifindex.Joakim Tjernlund2009-08-037-31/+34
| | | | | | * global: In struct ospf_path, change struct ospf_interface *oi to int ifindex. It is unsafe to reference *oi as an ospf interface can be deleted under your feet. Use a weak reference instead.
* ospfd: Discriminate better when selecting links between vertices in SPFJoakim Tjernlund2009-07-301-7/+5
| | | | | | | | * ospf_spf.c: (ospf_get_next_link) One must check the vertex type, Router or Network, to select type link to match against. Link type 1 has neighbour router ID in link_id and link type 2 has IP address of DR. Since router id may have same value as an existing IP address one risks matching a router ID against a DR.
* [bgpd] delete erroneous extra brace..Paul Jakma2009-07-301-1/+0
|
* bgpd: Workaround for invalid MBGP next hopMichael Lambert2009-07-301-0/+3
| | | | | | | | | * bgp_attr.c: (bgp_mp_reach_parse) There are some interoperability issues for MBGP (particularly IPv4 multicast NLRI) between different implementations. In order to get some next hops to install correctly in the BGP tables, it appears to be necessary to copy the multiprotocol next hop into the base next hop field. This is related to differences in RFC 2283 and RFC 2858.
* [doc] Update HACKINGPaul Jakma2009-07-301-14/+24
| | | | | * HACKING: Update to reflect git stripping []'s, and to allow for more discretion to avoid redundancy in commit messages.
* ospfd: Make ospf_if_lookup_recv_if() find the right unnumbered i/fJoakim Tjernlund2009-07-283-8/+15
| | | | | | | | | | | | | | | This function will return the interface for the first matching remote address for PtP i/f's. That won't work for multiple unnumbered i/f's as these may all have the same address. Pass in the struct interface pointer, ifp, to find the correct set of oi's to search in. This also reduces the size of the search list, making it faster. * ospfd/ospf_interface.c: Add struct interface * param to ospf_if_lookup_recv_if() to select the right list to search in. * ospfd/ospf_interface.h: ditto. * ospfd/ospf_packet.c: Pass new ifp argument to ospf_if_lookup_recv_if()
* ospfd: export ospf_if_table_lookup() and use it in ospf_network_run_interface()Joakim Tjernlund2009-07-283-6/+5
| | | | | | | | | | | Makes it possible to run OSPF on multiple PtP interfaces with the same remote address. * ospfd/ospf_interface.c: Export ospf_if_table_lookup(). * ospfd/ospf_interface.h: ditto. * ospfd/ospfd.c: (ospf_network_run_interface) Use ospf_if_table_lookup() to determine whether OSPF is already configured for a subnet and interface.
* bgpd/trivial: Fix indentation in previousPaul Jakma2009-07-282-35/+28
|
generated by cgit v1.2.3 (git 2.25.1) at 2025-08-02 07:32:01 +0000