1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
|
charon.plugins.kernel-netlink.buflen = <min(PAGE_SIZE, 8192)>
Buffer size for received Netlink messages.
charon.plugins.kernel-netlink.force_receive_buffer_size = no
Force maximum Netlink receive buffer on Netlink socket.
If the maximum Netlink socket receive buffer in bytes set by
_receive_buffer_size_ exceeds the system-wide maximum from
/proc/sys/net/core/rmem_max, this option can be used to override the limit.
Enabling this option requires special priviliges (CAP_NET_ADMIN).
charon.plugins.kernel-netlink.fwmark =
Firewall mark to set on the routing rule that directs traffic to our routing
table.
Firewall mark to set on the routing rule that directs traffic to our routing
table. The format is [!]mark[/mask], where the optional exclamation mark
inverts the meaning (i.e. the rule only applies to packets that don't match
the mark).
charon.plugins.kernel-netlink.mss = 0
MSS to set on installed routes, 0 to disable.
charon.plugins.kernel-netlink.mtu = 0
MTU to set on installed routes, 0 to disable.
charon.plugins.kernel-netlink.parallel_route = no
Whether to perform concurrent Netlink ROUTE queries on a single socket.
Whether to perform concurrent Netlink ROUTE queries on a single socket.
While parallel queries can improve throughput, it has more overhead. On
vanilla Linux, DUMP queries fail with EBUSY and must be retried, further
decreasing performance.
charon.plugins.kernel-netlink.parallel_xfrm = no
Whether to perform concurrent Netlink XFRM queries on a single socket.
charon.plugins.kernel-netlink.policy_update = no
Whether to always use XFRM_MSG_UPDPOLICY to install policies.
charon.plugins.kernel-netlink.port_bypass = no
Whether to use port or socket based IKE XFRM bypass policies.
Whether to use port or socket based IKE XFRM bypass policies.
IKE bypass policies are used to exempt IKE traffic from XFRM processing.
The default socket based policies are directly tied to the IKE UDP sockets,
port based policies use global XFRM bypass policies for the used IKE UDP
ports.
charon.plugins.kernel-netlink.receive_buffer_size = 0
Maximum Netlink socket receive buffer in bytes.
Maximum Netlink socket receive buffer in bytes. This value controls how many
bytes of Netlink messages can be received on a Netlink socket. The default
value is set by /proc/sys/net/core/rmem_default. The specified value cannot
exceed the system-wide maximum from /proc/sys/net/core/rmem_max, unless
_force_receive_buffer_size_ is enabled.
charon.plugins.kernel-netlink.roam_events = yes
Whether to trigger roam events when interfaces, addresses or routes change.
charon.plugins.kernel-netlink.set_proto_port_transport_sa = no
Whether to set protocol and ports in the selector installed on transport
mode IPsec SAs in the kernel.
Whether to set protocol and ports in the selector installed on transport
mode IPsec SAs in the kernel. While doing so enforces policies for inbound
traffic, it also prevents the use of a single IPsec SA by more than one
traffic selector.
charon.plugins.kernel-netlink.spdh_thresh {}
XFRM policy hashing threshold configuration for IPv4 and IPv6.
XFRM policy hashing threshold configuration for IPv4 and IPv6.
The section defines hashing thresholds to configure in the kernel during
daemon startup. Each address family takes a threshold for the local subnet
of an IPsec policy (src in out-policies, dst in in- and forward-policies)
and the remote subnet (dst in out-policies, src in in- and
forward-policies).
If the subnet has more or equal net bits than the threshold, the first
threshold bits are used to calculate a hash to lookup the policy.
Policy hashing thresholds are not supported before Linux 3.18 and might
conflict with socket policies before Linux 4.8.
charon.plugins.kernel-netlink.spdh_thresh.ipv4.lbits = 32
Local subnet XFRM policy hashing threshold for IPv4.
charon.plugins.kernel-netlink.spdh_thresh.ipv4.rbits = 32
Remote subnet XFRM policy hashing threshold for IPv4.
charon.plugins.kernel-netlink.spdh_thresh.ipv6.lbits = 128
Local subnet XFRM policy hashing threshold for IPv6.
charon.plugins.kernel-netlink.spdh_thresh.ipv6.rbits = 128
Remote subnet XFRM policy hashing threshold for IPv6.
charon.plugins.kernel-netlink.retries = 0
Number of Netlink message retransmissions to send on timeout.
charon.plugins.kernel-netlink.timeout = 0
Netlink message retransmission timeout, 0 to disable retransmissions.
charon.plugins.kernel-netlink.ignore_retransmit_errors = no
Whether to ignore errors potentially resulting from a retransmission.
charon.plugins.kernel-netlink.xfrm_acq_expires = 165
Lifetime of XFRM acquire state and allocated SPIs in kernel.
Lifetime of XFRM acquire state created by the kernel when traffic matches a
trap policy. The value gets written to /proc/sys/net/core/xfrm_acq_expires.
Indirectly controls the delay between XFRM acquire messages triggered by the
kernel for a trap policy. The same value is used as timeout for SPIs
allocated by the kernel. The default value equals the total retransmission
timeout for IKE messages, see IKEv2 RETRANSMISSION in
**strongswan.conf**(5).
|
