diff options
Diffstat (limited to 'modules/Installing/pages/medium.adoc')
-rw-r--r-- | modules/Installing/pages/medium.adoc | 10 |
1 files changed, 5 insertions, 5 deletions
diff --git a/modules/Installing/pages/medium.adoc b/modules/Installing/pages/medium.adoc index 990b340..583ae10 100644 --- a/modules/Installing/pages/medium.adoc +++ b/modules/Installing/pages/medium.adoc @@ -8,7 +8,7 @@ A very common consumer architecture is known as x86_64 - the traditional Intel x If you are installing Alpine to a traditional computer, this is most likely what you have. However, Alpine supports several other architectures for to-disk installation purposes: -// MAINT: supported/relevant arhitectures +// COMBAK: supported/relevant arhitectures x86_64:: the most common desktop, laptop and server architecture x86:: the older variant of x86_64, increasingly more rare, and limited to 4gb of ram ppc64le:: OpenPower-based systems, such as IBM's POWER8 @@ -16,13 +16,13 @@ s390x:: IBM Z-Systems and Mainframes Under some circumstances, you may also use armhf and aarch64 architectures - relevant to ARM chips, 32bit and 64bit respectively, the latter of which may support UEFI. -// MAINT: downloads page +// COMBAK: downloads page === Image Type Alpine offers a variety of downloadable https://alpinelinux.org/downloads/[images]. The image varieties relevant to this handbook are as follows: -// MAINT: image varieties +// COMBAK: image varieties standard:: A minimal installation image. Requires networking. @@ -42,7 +42,7 @@ If you aren't sure what image to use, you should use extended, assuming your arc Otherwise, you should use the standard image. == Downloading -// MAINT: downloads page +// COMBAK: downloads page === Obtaining the Chosen Media Image downloads are available at https://alpinelinux.org/downloads/[alpinelinux.org]. Press the button under your chosen image type, that corresponds to your target architecture. @@ -185,7 +185,7 @@ You can then find the line starting with `linux`, and add or remove parameters f ==== [Isolinux] Modifying Kernel Command Line Under isolinux, there is no graphical editor, but you can specify the kernel command line directly. -// MAINT: primary image name +// COMBAK: primary image name To do so, you must select the correct label (for example, `vanilla` or `virt`), and add your parameters there. For example, if you wanted to add `rootflags=noatime` to your kernel command line, your isolinux prompt should look as so: |