aboutsummaryrefslogtreecommitdiffstats
path: root/doc/standards/rfc4478.txt
blob: 45bf3253644fa538cc349eb40e17b141da8d382c (plain)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
123
124
125
126
127
128
129
130
131
132
133
134
135
136
137
138
139
140
141
142
143
144
145
146
147
148
149
150
151
152
153
154
155
156
157
158
159
160
161
162
163
164
165
166
167
168
169
170
171
172
173
174
175
176
177
178
179
180
181
182
183
184
185
186
187
188
189
190
191
192
193
194
195
196
197
198
199
200
201
202
203
204
205
206
207
208
209
210
211
212
213
214
215
216
217
218
219
220
221
222
223
224
225
226
227
228
229
230
231
232
233
234
235
236
237
238
239
240
241
242
243
244
245
246
247
248
249
250
251
252
253
254
255
256
257
258
259
260
261
262
263
264
265
266
267
268
269
270
271
272
273
274
275
276
277
278
279
280
281
282
283






Network Working Group                                             Y. Nir
Request for Comments: 4478                                   Check Point
Category: Experimental                                        April 2006


   Repeated Authentication in Internet Key Exchange (IKEv2) Protocol

Status of This Memo

   This memo defines an Experimental Protocol for the Internet
   community.  It does not specify an Internet standard of any kind.
   Discussion and suggestions for improvement are requested.
   Distribution of this memo is unlimited.

Copyright Notice

   Copyright (C) The Internet Society (2006).

Abstract

   This document extends the Internet Key Exchange (IKEv2) Protocol
   document [IKEv2].  With some IPsec peers, particularly in the remote
   access scenario, it is desirable to repeat the mutual authentication
   periodically.  The purpose of this is to limit the time that security
   associations (SAs) can be used by a third party who has gained
   control of the IPsec peer.  This document describes a mechanism to
   perform this function.

1.  Introduction

   In several cases, such as the remote access scenario, policy dictates
   that the mutual authentication needs to be repeated periodically.
   Repeated authentication can usually be achieved by simply repeating
   the Initial exchange by whichever side has a stricter policy.

   However, in the remote access scenario it is usually up to a human
   user to supply the authentication credentials, and often Extensible
   Authentication Protocol (EAP) is used for authentication, which makes
   it unreasonable or impossible for the remote access gateway to
   initiate the IKEv2 exchange.

   This document describes a new notification that the original
   Responder can send to the original Initiator with the number of
   seconds before the authentication needs to be repeated.  The
   Initiator SHOULD repeat the Initial exchange before that time is
   expired.  If the Initiator fails to do so, the Responder may close
   all Security Associations.




Nir                           Experimental                      [Page 1]

RFC 4478            Repeated Authentication in IKEv2          April 2006


   Repeated authentication is not the same as IKE SA rekeying, and need
   not be tied to it.  The key words "MUST", "MUST NOT", "SHOULD",
   "SHOULD NOT", and "MAY" in this document are to be interpreted as
   described in [RFC2119].

2.  Authentication Lifetime

   The Responder in an IKEv2 negotiation MAY be configured to limit the
   time that an IKE SA and the associated IPsec SAs may be used before
   the peer is required to repeat the authentication, through a new
   Initial Exchange.

   The Responder MUST send this information to the Initiator in an
   AUTH_LIFETIME notification either in the last message of an IKE_AUTH
   exchange, or in an INFORMATIONAL request, which may be sent at any
   time.

   When sent as part of the IKE SA setup, the AUTH_LIFETIME notification
   is used as follows:

      Initiator                            Responder
      -------------------------------      -----------------------------
      HDR, SAi1, KEi, Ni              -->
                                      <--  HDR, SAr1, KEr, Nr, [CERTREQ]
      HDR, SK {IDi, [CERT,] [CERTREQ,]
         [IDr,] AUTH, SAi2, TSi, TSr} -->
                                      <--  HDR, SK {IDr, [CERT,] AUTH,
                                                    SAr2, TSi, TSr,
                                                     N(AUTH_LIFETIME)}

   The separate Informational exchange is formed as follows:

                                      <--  HDR, SK {N(AUTH_LIFETIME)}
      HDR  SK {}                      -->

   The AUTH_LIFETIME notification is described in Section 3.

   The original Responder that sends the AUTH_LIFETIME notification
   SHOULD send a DELETE notification soon after the end of the lifetime
   period, unless the IKE SA is deleted before the lifetime period
   elapses.  If the IKE SA is rekeyed, then the time limit applies to
   the new SA.

   An Initiator that received an AUTH_LIFETIME notification SHOULD
   repeat the Initial exchange within the time indicated in the
   notification.  The time is measured from the time that the original
   Initiator receives the notification.




Nir                           Experimental                      [Page 2]

RFC 4478            Repeated Authentication in IKEv2          April 2006


   A special case is where the notification is sent in an Informational
   exchange, and the lifetime is zero.  In that case, the original
   responder SHOULD allow a reasonable time for the repeated
   authentication to occur.

   The AUTH_LIFETIME notification MUST be protected and MAY be sent by
   the original Responder at any time.  If the policy changes, the
   original Responder MAY send it again in a new Informational.

   The new Initial exchange is not altered.  The initiator SHOULD delete
   the old IKE SA within a reasonable time of the new Auth exchange.

3.  AUTH_LIFETIME Notification

   The AUTH_LIFETIME message is a notification payload formatted as
   follows:

                           1                   2                   3
       0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1
      +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
      ! Next Payload  !C!  RESERVED   !         Payload Length        !
      +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
      !  Protocol ID  !   SPI Size    !      Notify Message Type      !
      +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
      !                           Lifetime                            !
      +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+

      o  Payload Length is 12.
      o  Protocol ID (1 octet) MUST be 0.
      o  SPI size is 0 (SPI is in message header).
      o  Notify Message type is 16403 by IANA.
      o  Lifetime is the amount of time (in seconds) left before the
         peer should repeat the Initial exchange.  A zero value
         signifies that the Initial exchange should begin immediately.
         It is usually not reasonable to set this value to less than 300
         (5 minutes) since that is too cumbersome for a user.
         It is also usually not reasonable to set this value to more
         than 86400 (1 day) as that would negate the security benefit of
         repeating the authentication.

4.  Interoperability with Non-Supporting IKEv2 Implementations

   IKEv2 implementations that do not support the AUTH_LIFETIME
   notification will ignore it and will not repeat the authentication.
   In that case the original Responder will send a Delete notification
   for the IKE SA in an Informational exchange.  Such implementations
   may be configured manually to repeat the authentication periodically.




Nir                           Experimental                      [Page 3]

RFC 4478            Repeated Authentication in IKEv2          April 2006


   Non-supporting Responders are not a problem because they will simply
   not send these notifications.  In that case, there is no requirement
   that the original Initiator re-authenticate.

5.  Security Considerations

   The AUTH_LIFETIME notification sent by the Responder does not
   override any security policy on the Initiator.  In particular, the
   Initiator may have a different policy regarding re-authentication,
   requiring more frequent re-authentication.  Such an Initiator can
   repeat the authentication earlier then is required by the
   notification.

   An Initiator MAY set reasonable limits on the amount of time in the
   AUTH_LIFETIME notification.  For example, an authentication lifetime
   of less than 300 seconds from SA initiation may be considered
   unreasonable.

6.  IANA Considerations

   The IANA has assigned a notification payload type for the
   AUTH_LIFETIME notifications from the IKEv2 Notify Message Types
   registry.

7.  Normative References

   [IKEv2]    Kaufman, C., "Internet Key Exchange (IKEv2) Protocol", RFC
              4306, December 2005.

   [RFC2119]  Bradner, S., "Key words for use in RFCs to Indicate
              Requirement Levels", BCP 14, RFC 2119, March 1997.

Author's Address

   Yoav Nir
   Check Point Software Technologies

   EMail: ynir@checkpoint.com













Nir                           Experimental                      [Page 4]

RFC 4478            Repeated Authentication in IKEv2          April 2006


Full Copyright Statement

   Copyright (C) The Internet Society (2006).

   This document is subject to the rights, licenses and restrictions
   contained in BCP 78, and except as set forth therein, the authors
   retain all their rights.

   This document and the information contained herein are provided on an
   "AS IS" basis and THE CONTRIBUTOR, THE ORGANIZATION HE/SHE REPRESENTS
   OR IS SPONSORED BY (IF ANY), THE INTERNET SOCIETY AND THE INTERNET
   ENGINEERING TASK FORCE DISCLAIM ALL WARRANTIES, EXPRESS OR IMPLIED,
   INCLUDING BUT NOT LIMITED TO ANY WARRANTY THAT THE USE OF THE
   INFORMATION HEREIN WILL NOT INFRINGE ANY RIGHTS OR ANY IMPLIED
   WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE.

Intellectual Property

   The IETF takes no position regarding the validity or scope of any
   Intellectual Property Rights or other rights that might be claimed to
   pertain to the implementation or use of the technology described in
   this document or the extent to which any license under such rights
   might or might not be available; nor does it represent that it has
   made any independent effort to identify any such rights.  Information
   on the procedures with respect to rights in RFC documents can be
   found in BCP 78 and BCP 79.

   Copies of IPR disclosures made to the IETF Secretariat and any
   assurances of licenses to be made available, or the result of an
   attempt made to obtain a general license or permission for the use of
   such proprietary rights by implementers or users of this
   specification can be obtained from the IETF on-line IPR repository at
   http://www.ietf.org/ipr.

   The IETF invites any interested party to bring to its attention any
   copyrights, patents or patent applications, or other proprietary
   rights that may cover technology that may be required to implement
   this standard.  Please address the information to the IETF at
   ietf-ipr@ietf.org.

Acknowledgement

   Funding for the RFC Editor function is provided by the IETF
   Administrative Support Activity (IASA).







Nir                           Experimental                      [Page 5]